Multipro Cancel The title field is required!

1. Timothy Walker

   

   0 posts
   
   5/16/2013 8:05 PM

   Anyone have an issue with low voltage? I have the multipro 1100 and put a new battery in last month and today I went out to spray and the computer wouldn't function properly (toro. Pro control). It needs 12 volts to operate and I had 11.4 volts. Could it be the alternator? Or is there any other possibilities? Thanks in advance.

   
   
   
   
2. DeMay Ryan

   
   5/18/2013 2:05 AM

   Any chance you jumped the sprayer when the old battery was still in there? If so, and if the computer was still connected then there is a chance it is fried. Made this mistake years sgo and had to send it to Raven to br rebuilt.

   
   
   
   
3. John Parmelee

   

   0 posts
   
   5/18/2013 10:05 AM

   Hey Tim
   
   Maybe check out the voltage regulator rectifier -I think that's what they call it? I had some issues with solenoids not functioning properly, ended up changing the battery but still acted funny... it was the regulator. Worth a try.
   
   John

   
   
   
   
4. Timothy Walker

   

   0 posts
   
   5/18/2013 1:05 PM

   Thanks guys.
   
   We are investigating the issue.
   
   The battery has 11 volts and is not charging. I don't recall jumping the battery before....we did replace it when the rig wouldn't start about a month ago.

   
   
   
   
5. Kevin Tansey

   

   0 posts
   
   5/21/2013 7:05 PM

   Tim,
   
   We had a similar problem with ours and it turned out to be a bad key switch. Not sure if it will be the same for you but it's worth looking at.