8/9/2015 8:08 PM
found this old notice online... hope this helps
Solution Number: 8113
Solution Summary: PIP 96RW128 FUEL SHUT-OFF SOLENOID IMPROVEMENT / FIX-AS-FAIL
Publication Date: Aug 4 2003
--------------------------------------------------------------------------------
**Paper copies of solutions may not be the most current solutions**
This PIP has terminated, and PIP claims will no longer be accepted.
COMPLAINT:
* - Engine will die and not restart.
* - Engine may exhibit low power or run rough when hot.
PROBLEM:
All tractors have higher than expected fuel shut-off solenoid failure
due to manufacturing problems with plastic bobbin that the wires
connect around. Tractors within a known serial number range are
suspect.
PRODUCTS AFFECTED:
For reference, tractors in this program will be within the following
serial number range:
5200 (220563-420322), 5300 (230622-430831), 5400 (240597-460190)
6200 (109272-134969), 6300 (109272-134969), 6400 (109272-134969)
7200 (001002-003130), 7400 (001002-003326)
CORRECTION:
Install MPCD10021 Shut-off Solenoid Kit on 5000 and 6000 Series
tractors or RE54064 Shut-off Solenoid on 7200 and 7400 tractors.
SPECIAL TOOLS:
None needed.
KIT INFORMATION:
All kits/parts are to be ordered from PDC. They will not be
automatically ordered for since this is a Fix-as-Fail program.
LABOR:
Install shut-off solenoid kit/part: 0.5 hrs.
ACCOUNTING:
Please prepare DC-255 for each tractor repaired in this program.
Make sure that tractor model number, serial number, program number
and factory account code number (09-492) are on each claim completed.
EXPIRATION DATE:
01 April 1998
DISPOSITION OF PARTS:
Scrap all replaced parts using service administration guidelines.
ADDITIONAL INFORMATION:
Another way to identify suspect solenoids is as follows;
Before installing new solenoid, check for 'Lucas/Cav' manufacturing
code rather than 'Roto-Diesel'
Solenoids can be identified by a four (4) digit code stamped on the
body. First two (2) digits indicate week number and last two (2) are
the year. For example; Code 1594 means week number 15 (11-16 April)
of 1994.
Do NOT use any solenoid with manufacturing codes from 1293
(22-27 MAR 93) up to 2694 (27 JUN - 02 JUL 94).
Any parts with single upright stud are probably 'Roto-Diesel' and
should not be used. Unpainted pieces will say 'Roto-Diesel' on top
cover near stud. 'Lucas/Cav' pieces have flat top with threaded
hole.
Solenoids in your inventory with codes between 1293 and 2694 or from
'Roto-Diesel' should be returned to your parts depot using regular
parts return procedure.
IMPORTANT:
Under normal operation, shut-off solenoid can be 'HOT' to the touch.
UPDATED: 09 JUN 95 / MJ
UPDATED: 29 JUL 96 / JC
--------------------------------------------------------------------------------
6400, 6300, 5400, 6200, 5400N, 7200, 7400, 5300, 5200
--------------------------------------------------------------------------------
ERRATIC, WIRE, FAIL, RPM, POWER, SWITCH, START, LOW, PIP, FUEL, INJECTION, STOP, HARD, PTS, 96RW128, MPCD10021, RE54064, FA, PIP, ENG, F1606, F1808, F0413, F0400