Toro LTC PLUS changing itself from Central to No Response Cancel The title field is required!

1. Michael Rogers

   

   2 posts
   
   2/10/2017 4:02 AM

   Hello,
   
   For the last three evenings my Toro LTC Plus satellite system was in Central Mode when I left the golf course and it switched itself to No Response and nothing irrigated. If I shutdown the central computer and turn it back on again it is back in Central Mode, the same the day before.
   
   Yesterday I did a manual download in mid morning to see if it would trip off back to No Response. It stayed in Central Mode. Yesterday evening at 6 : 15 it was back in No Response.
   
   Does anybody have any similar experiences? Thanks Michael
   
   Marbella Golf Country Club
   Costa del Sol España

   
   
   
   
2. Andrew Cross

   

   5 posts
   
   2/10/2017 12:02 PM

   The controllers have 3 modes, Central, Stand-Alone, and Off. I believe from Site Pro you can send the command to switch from one to the other. It's under the multi-manual tab. I have 1 satellite that will occasionally switch to Stand-Alone, usually after a power interruption.
   
   I will run a satellites with reports everyday to verify all are communicating and ready to download the nights programs. I set it to show the following options (No Communication/Response, Stand-Alone Mode, or Off). So run the report and if just shows the satellite names and no sub messages then we are good to go!
   
   https://www.mytoronsn.com/Resources/Attachment?attachmentId=150&title=LTC%2B%20User%20Guide%20371-0011.pdf