aerifing tines Cancel The title field is required!

1. James Cola

   

   0 posts
   
   9/30/2015 1:09 PM

   Anybody have any tricks for keeping in aerifng tines on a toro fairway aerifier. I have a few spots that we can't figure out a solution to keep the tines tight enough. Replacement of the holders is costly and I thought maybe someone could give me a good idea. thanks.

   
   
   
   
2. Christopher Thuer

   

   101 posts
   
   9/30/2015 5:09 PM

   We had similar problems with 648 and Deere fairway aerator. Tried a layer of tape to no avail. The only remedy was change holders which worked.

   
   Chris Thuer, CGCS, Bear Slide Golf Club, Cicero, IN
   
   
3. Henry Heinz

   

   0 posts
   
   10/1/2015 8:10 AM

   Take your tine holders and just add two small spot-weld dots in the center. Tighten down with your impact an no more issues.
   
   Regards,

   
   
   
   
4. Steve Datwyler

   

   2 posts
   
   11/11/2015 6:11 PM

   We put a small amount of red Loctite on each of the tines and this solved the problem. The tines come out just fine and no residue builds up on the tine holders.