Nemacur Settings Cancel The title field is required!

1. Joshua Kelley

   

   0 posts
   
   3/27/2014 6:03 PM

   Does anyone know the settings for applying Nemacur? I have Anderson's and Lesco Rotary Spreaders and Lesco Drop Spreader. I'd prefer to drop spread.

   
   
   
   
2. Steven Huffstutler

   

   11 posts
   
   3/28/2014 8:03 AM

   The rate is 2.3lbs / Mft2
   You'll have to calibrate your own spreader 'cause they're all different
   
   
   Regards,
   
   Steve

   
   
   
   
3. James Smith

   

   112 posts
   
   3/28/2014 9:03 AM

   Personally I would use the rotary spreader. While it does put more chemical in the air you will take a lot less time with the chemical that way. Nemacure is made in gray coloration and you most likely will not be able to see where it goes down when you are applying it. One thing that I have been doing with granular that cannot be seen when applying them is to topdress the green lightly and then make the application so you can see where your tire tracks are.
   
   You def. need to calibrate your own spreader.

   
   
   
   
4. Joshua Kelley

   

   0 posts
   
   3/29/2014 10:03 PM

   BY the time I get done calibrating it I'll be out of Nemacure.

   
   
   
   
5. Steven Huffstutler

   

   11 posts
   
   4/2/2014 2:04 PM

   Come on, man. Do it on concrete and sweep it up.

   
   
   
   
6. Wahlin Scott B

   
   4/3/2014 12:04 AM

   Nemacur is on the oil dry that you see in the bag. You can use oil dry to calibrate the spreader. They used to provide "blank" Nemacur for calibration and all it was was oil dry. The current label is Nemacur 10G at 100#/A. It used to be Nemacur 15G at 200#/A - 50% more concentrated material at 2X the rate.