toro 3050 hydraulic lift cylinder Cancel The title field is required!

1. Ron Mosher

   

   0 posts
   
   7/31/2015 12:07 PM

   Has anyone repaired a toro 3050 hydraulic lift cylinder? How do you get into it to replace the seals? Any ideas?

   
   
   
   
2. John Moore

   

   0 posts
   
   7/31/2015 1:07 PM

   Hope you get this.

   
   
   
   
3. Ron Mosher

   

   0 posts
   
   7/31/2015 4:07 PM

   The lift cylinders I have do not have the snap ring on the top like your picture. There is a notch on the side where you can see a snap ring. I just can't figure out how to get to the snap ring inside to release it. There are a series of holes on the removable top end.

   
   
   
   
4. Bob Pruneau

   

   5 posts
   
   8/2/2015 12:08 PM

   You need a lot of penetrating fluid and heat . The hole on top are for a gland wrench . It will spin I think clock wise and the clip will roll out of the hole ( best case scenario) I had to heat mine to get it off since your replacing seals any way . Don't heat it to the point where it's going to melt and aluminium parts . You can buy new clips . Look like a piece of 1/8 square stock .

   
   
   
   
5. John Moore

   

   0 posts
   
   8/3/2015 5:08 AM

   Ok, this one.

   
   
   
   
6. Blas Huezo

   

   1 posts
   
   8/18/2015 12:08 PM

   Ron,
   See if this helps.