Cushman Truckster Cancel The title field is required!

1. Brandon Crago

   

   0 posts
   
   10/3/2012 3:10 PM

   Need help truckster was running fine as a sprayer switched it over to pick up cores during aerification started once and now will not start usually can here fuel pump pumping prior to starting now can not here that appears to have no power to the fuel pump we have checked all fuses and replaced all the relays now we are stumped.

   
   
   
   
2. Brouse Jeffrey W

   
   10/6/2012 9:10 AM

   Check the continuity of the wire going from the relay to the pump, I have had a wire go bad on a tractor and it drove me crazy (short trip) .
   
   Jeff Brouse
   Cherokee Golf Course
   Danville, PA

   
   
   
   
3. Henry Heinz

   

   0 posts
   
   10/6/2012 10:10 AM

   If you have a power probe, hook it up to the battery and unplug your fuel pump. Take the ground wire on the power probe and hook to one side of the pump and then the probe to the other and energize it with 12 volts and see if it pumps, if not the fuel pump is bad. You can also check you wiring coming to the fuel pump as well with probe and see if your getting power and just how many volts are flowing to your pump connection. A wise investment is the power probe III... I have like three of the 3's and and one of the 2's still left from back in the day. The 3 will give you voltage readings. It's a very sweet tool.........
   
   Regards,

   
   
   
   
4. Joe Brophy

   

   0 posts
   
   10/9/2012 2:10 PM

   On our cushman the computer went out and it did what yours is doing.As a test we ran a wire from batt. to fuel pump and it worked.

   
   
   
   
5. Sutter Frank E

   
   11/14/2013 3:11 PM

   I am in need of a rear hub for model # 898530-8510, VIN# 1CUMH2222FL003106. Hopefully someone might have an old truckster in their junk pile. This is a mid 80's truckster (I think). I would be happy to buy it. Any help would be appreciated. You can email me at: slick154@frontier.com or phone 309 475-4111.