Core Harvester Cancel The title field is required!

1. Lee Medeiros

   

   0 posts
   
   2/19/2016 3:02 PM

   Has anyone connected a core harvester to the high pressure hydraulic side of a new Toro MDX Workman? It has a separate hydraulic tank from the low side witch runs off the transaxle. I would like to use the dump at the same time so I rather not connect the harvester to the low side if possible.

   
   
   
   
2. William Huber

   

   0 posts
   
   2/22/2016 2:02 PM

   You can hook the conveyor motors directly to the high volume side of the HDX and still use the dump feature. You have to use the hydraulic motor that does not have the case drain on it, (Not the motor that comes with the old Toro conversion kit but the one that comes with the core harvester). I think the motor number is 832401. If you hook the case drain up to the rear differential like the older style it will just overflow the rear differential. Hope that helps.

   
   
   
   
3. Lee Medeiros

   

   0 posts
   
   2/26/2016 3:02 PM

   Thank you for your response. I also found out from Toro that you can place a T just before the high flow filter that goes back to the hi flow hydraulic tank. Then hook up the return line to that.